LT6350CMS8#TRPBF

LT6350 is a low noise single-ended to differential converter/ADC driver featuring fast settling time. It converts a high or low impedance, single-ended input signal to a low impedance, balanced, differential output suitable for driving high performance differential successive approximation register (SAR) ADCs. The two op-amp topology features very low noise op-amps, that can support SNR <gt/>110dB in a 1MHz bandwidth. The input op-amp is trimmed for constant low input-referred voltage offset over the input range to prevent VOS steps from degrading distortion. On a single 5V supply, the outputs can swing from 55mV to 4.945V. With the addition of a negative supply, it can swing from 0V to 4.945V. Output common mode voltage is set by applying a voltage to the +IN2 pin. Application includes 16-bit and 18-bit SAR ADC drivers, single-ended to differential conversion, differential line driver.

• Rail-to-rail input and outputs, no external gain resistors required
• High impedance input, low power shutdown
• 240ns typical settling time to a 4V input step (0.01%, TA = 25°C)
• 85MHz typical gain-bandwidth product frequency = 1MHz (op-amp 1, non-inverting)
• 108dB typical power supply rejection ratio (VS = 2.7V to 12V, TA = 25°C)
• Supply voltage range from 2.7V to 12V (TA = 25°C, V+ = 5V, V– = 0V)
• 1000 ohm internal resistors (TA = 25°C, V+ = 5V, V– = 0V)
• 94dB typical common mode rejection ratio, op-amp 1 (VS = 5V, V+IN1 = V–IN1 = V– +1.5V to V+)
• 48V/µs differential slew rate (TA = 25°C, OUT1 rising, OUT2 falling))
• 8 lead plastic MSOP package, specified temperature range from 0°C to 70°C

Notas

ADI products are only authorized (and sold) for use by the customer and are not to be resold or otherwise passed on to any third party